|
|
|
11-09-2011
|
#1 |
Join Date: Aug 2006
Location: Houston, TX
Posts: 67
|
FS: Pressure plates
I have 2 used pressure plates for sale. All parts are located in Houston, Tx.
1. Centerforce pressure plate - less than 16k miles, good condition. $75 +shipping +paypal fees.   2. Factory ZR-1 pressure plate - from a 94 ZR-1 with approximately 35k miles on it, good condition. $50 +shipping +paypal fees.   Aaron |
|
|
|
11-10-2011
|
#2 |
  
Join Date: Aug 2005
Location: Northridge, CA
Posts: 1,461
|
Re: FS: Pressure plates
Why did you take them off?
|
|
|
|
|
11-10-2011
|
#3 |
|
Join Date: Aug 2006
Location: Houston, TX
Posts: 67
|
Re: FS: Pressure plates
The Centerforce pressure plate was taken off when it was discovered that the clutch disc was bad. My wife bought me a new pressure plate and clutch disc as a present. So that went on instead of just replacing the disc.
I got the factory pressue plate when I purchased some other parts from a member. This pressure plate was taken off when a fidanza aluminum flywheel swap was done. |
|
|
|
|
11-10-2011
|
#4 |
|
Join Date: Jun 2009
Location: I live at Devens, one run at a time
Posts: 455
|
Re: FS: Pressure plates
Any chance you can tell which one is lighter?
Thanks, - Jeff
__________________
[I]91 ZR-1 #1840, autocrossing in SCCA BSP. FIC S/S's DRM chip/Watson/Borla/lid/LW batt&headlights, springs, shocks, pads & lines, quick rack & Turn One, camber brace, 32/22mm sways, A/C halfway deleted 17x11 & 12 CCW's, 315 & 335 Hoosier A6s [/I] |
|
|
|
|
11-10-2011
|
#5 |
|
Join Date: Aug 2006
Location: Houston, TX
Posts: 67
|
Re: FS: Pressure plates
batchman - they both weigh a little over 16 lbs. If there is a difference it is less than 1/2 lb.
Aaron |
|
|
|
 |
|
|
Hybrid Mode
