|
![]() |
#1 |
![]() Join Date: Nov 2010
Location: Japan
Posts: 30
|
![]()
Hi.
I am a new owner of a ZR-1(1991) and am enjoying it every weekend. I am very happy now ![]() BTW, please let me ask you a beginner question. I would like to know whether the rear end of my ZR-1 is normal or not. When I accelerate my ZR1 to 7000 rpm with 5th gear, the GPS speedometer reads 223.9 km/h(about 140 mph). Is this normal? Is the max speed of ZR-1 accomplished by 6th gear? I am wondering if the rear end ratio of my ZR-1 is normal or not. *the rear tires are Nitto NT555(315/35-17). *the original speedometer reads about 219 km/h(136 mph) at 7000 rpm with 5th gear. Thanks in advance. Y. Honda 1991 ZR-1 Last edited by gorgeousgeorge; 11-08-2010 at 05:04 PM. |
![]() |
![]() |
![]() |
#2 |
Join Date: May 2005
Location: Leesburg, VA
Posts: 2,704
|
![]()
7,000 in 5th gear would be about 200mph (320kph) with stock gearing. That would suggest you have around a 5:1 rear gear ratio. Some Jeeps use the D44, so there are probably some pretty extreme gears available out there.
It sounds like your speedometer has been corrected properly, though. |
![]() |
![]() |
![]() |
#3 |
Join Date: Apr 2009
Location: Prather, CA
Posts: 804
|
![]()
It's possible his tach isn't reading correctly also.
|
![]() |
![]() |
![]() |
#4 |
![]() Join Date: Aug 2008
Location: Houston, TX
Posts: 2,314
|
![]()
Wow! That would be some serious rear gears. Mine with stock 3.45 hits 181mph at 7100 rpm,s.
|
![]() |
![]() |
![]() |
#5 |
![]() Join Date: Nov 2010
Location: Japan
Posts: 30
|
![]()
Thank you for your interesting replies!
![]() I understand that 140 mph at 7000rpm in 5th gear is NOT normal for ZR-1. The problem would be that the rear end ratio is not normal or the tachometer is not correct. I think I have to inspect the rear end ratio at first. Does the method below work well to inspect the ratio? 1. lift the car up. 2. mark a dot with chalk on circumference of the propeller shaft. 3. mark a dot with chalk on the rear tire wall. 4. rotate rear tire and drive the propeller shaft. 5. count the number of rotation of the tire required to have the propeller shaft make one complete rotation. I am not a gearheaded guy ![]() Thank you! Yoshi Honda 1991 ZR-1 |
![]() |
![]() |
![]() |
#6 |
![]() Join Date: Dec 2004
Location: Jacksonville, FL USA
Posts: 4,609
|
![]()
Hi! Yes that will work to get you a very close approximation of the gear ratio,
![]() Tom
__________________
1990 ZR-1, Black/grey, #2233, stock. ZR-1 Net Reg Founding Member #316 & NCM member |
![]() |
![]() |
![]() |
#7 |
![]() Join Date: Dec 2004
Location: Luling, TX
Posts: 97
|
![]() |
![]() |
![]() |
![]() |
#8 |
![]() Join Date: Aug 2008
Location: Houston, TX
Posts: 2,314
|
![]()
My tach is off now. Corey even said it was off in the high direction 1000rpm's. Now it reads 8000 at 181mph which to me says 7100 is about right for that speed.
|
![]() |
![]() |
![]() |
#9 | |
![]() Join Date: Dec 2004
Location: Luling, TX
Posts: 97
|
![]() Quote:
Using a 25.7" diameter tire, @ 7100 rpm with 3.45 gears and in 5th gear you should be at about 209 mph. It is a little easier to figure using 4th gear as it is 1:1 rather than 1:.75. Nevertheless, 180 should be about 6100 rpm in 5th with 3.45 gears and 25.7" diameter tire. Of course, that is assuming little or no strech on the tire or loss of traction. With 4.10 gears 180 mph is about 7400 rpm and that is about what my tach showed in the 2001 BBORR. I ran the race with 4.10 gears. It would run 180 in 5th and 181 in 6th. That was all it would do. I went across the finish line at about 7400 in 5th gear and the pedal to the metal (or fiberglass) trying to put my foot up to the radiator. Speedo said 180. At that time the speedo and tach were quite accurate according to testing on dyno. In the 2001 race I had about 372 rwhp. In the 2002 race, I had about 392 rwhp and 3.45 gears. Speedo was not as accurate after gear change even though we put in what we thought was the correct trans speedo gear for the 3.45. It read a little low. As well as I remember, the tach was bouncing some at around 7000 with the speedo at 201. Radar also got me at 201 but after 2 or 3 miles of 201 I let off before the end of the 7 mile straight. Don't know where the radar was located. I came out of the corner into the straight running about 160 or so and it took 2 or 3 miles to get to 201. All the above is just for info. Curtis |
|
![]() |
![]() |
![]() |
#10 |
Join Date: Mar 2009
Location: Orlando, FL
Posts: 1,816
|
![]()
My bet is inaccurate tach
![]() |
![]() |
![]() |
![]() |
|
|