clutch disc pic please - ZR-1 Net Registry Forums

hihok9 · 05-19-2010

Installing my clutch disc with hydraulic throwout bearing and had no old one to go by..... Assembly manual is not clear and RAM directions are poor..... anybody got a pic of which side goes toward engine. Don't want to make that mistake. Thanks!

Wide_One · 05-19-2010

Are you replacing the slave cylinder with the ram kit?

rhipsher · 05-19-2010

Here you go.

A26B · 05-19-2010

I think he wanted photos of the disc.

rhipsher · 05-19-2010

Quote:

Originally Posted by A26B

I think he wanted photos of the disc.

oops. that's easy enough without a photo. most disks have a sticker that says flywheel side. Look at your disk where the 26 tooth spline is. One side is flush with the face and the other protrudes about an inch. the protruding side faces your flywheel/engine.

hihok9 · 05-19-2010

Thanks! That's what I was looking for. There is a small collar on the side I put toward the engine.... maybe a half inch... and the side toward the tranny was a couple flat plates maybe 1/4 in wide six inches across, wide and smooth, not like the collar on the other side. The slave is the throwout, uses the stock firewall master. I had to cut the boss off the bellhousing for the slave to make clearance in my application. The hydraulic system came with aluminum flywheel as well. That's when I found out all about having to get shorter bolts ..... Learning as I go.

05-19-2010	#1
hihok9 Join Date: Jul 2005 Posts: 49	clutch disc pic please Installing my clutch disc with hydraulic throwout bearing and had no old one to go by..... Assembly manual is not clear and RAM directions are poor..... anybody got a pic of which side goes toward engine. Don't want to make that mistake. Thanks!

05-19-2010	#2
Wide_One Join Date: Dec 2004 Location: San Ramon Ca Posts: 32	Re: clutch disc pic please Are you replacing the slave cylinder with the ram kit?

05-19-2010	#3
rhipsher Join Date: Aug 2008 Location: Houston 90 Red ZR-1 Posts: 2,320	Re: clutch disc pic please Here you go.

05-19-2010	#4
A26B Join Date: Dec 2003 Location: Arcadia,OK Posts: 3,394	Re: clutch disc pic please I think he wanted photos of the disc. __________________ Jerry Downey JERRYS LT5 GASKETS & PARTS http://www.jerrysgaskets.com 1994 *ZR-1*, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc. 2016 Black-Red, 3LT-Z51 Auto 8-speed.

05-19-2010	#6
hihok9 Join Date: Jul 2005 Posts: 49	Re: clutch disc pic please Thanks! That's what I was looking for. There is a small collar on the side I put toward the engine.... maybe a half inch... and the side toward the tranny was a couple flat plates maybe 1/4 in wide six inches across, wide and smooth, not like the collar on the other side. The slave is the throwout, uses the stock firewall master. I had to cut the boss off the bellhousing for the slave to make clearance in my application. The hydraulic system came with aluminum flywheel as well. That's when I found out all about having to get shorter bolts ..... Learning as I go.