Stud Kit for Cylinder Heads and Main Bearing Caps

[Jagdpanzer]

I work for a German engine company and can get about any metric fastener that exits, either off the shelve or special made. I would like to look into putting together a stud kit to replace all of the cylinder head and main bearing cap bolts on both two bolt and four bolt blocks. Can someone knowledgeable provide the necessary specs:

• Fastener size,
• Stud length
• Thread pitch
• Threaded length
• Strength grade
• Any other important info

[Polo-1]

Ron Woods has the head studs from ARP.

I can get the 2 bolt main measurement's on Monday. I can tell you ARP wants over $178 per stud not including the nut and washer. When I told them to build me 3 sets, never heard from them again.

[Jagdpanzer]

Originally Posted by Polo-1

Ron Woods has the head studs from ARP.

I can get the 2 bolt main measurement's on Monday. I can tell you ARP wants over $178 per stud not including the nut and washer. When I told them to build me 3 sets, never heard from them again.

Any idea what the ARP head studs measure?

[Jagdpanzer]

Had a dream last night that I started work on the mother of all LT5 big bore strokers

Originally Posted by Jagdpanzer

Had a dream last night that I started work on a big bore LT5 stroker

I almost fell off my chair........good one.

[Polo-1]

Here is what I have......
For 2 bolt blocks.