|
![]() |
#1 |
![]() Join Date: Jul 2004
Location: Kalamazoo MI
Posts: 1,764
|
![]()
Looking for opinions what do you hear?
It is a DRM 500 package top end ported It has aftermarket connecting rods, after market pistons marked PMI388/I not sure about the cylinder liners, and I am pretty sure it had Nitrous run on it from the holes drilled in my storage compartment. I have no idea the abuse this engine had prior to me getting it but it has been fine for 19 years with a couple of misfire issues here and there. I have been driving it as a daily for years and it has always puffed a little oil smoke. I know I have something going on so im not to worried about it just want to figure it out before I yank it out. Video https://www.youtube.com/watch?v=5V4tnQdGc6Q I had Amsoil 10w40 high zinc in it put in last spring. I checked all over the place with my mechanic stethoscope couldn't really isolate it. Oil pressure was still good Last compression test was good but I have not checked it yet. I am pulling the oil pan to check for anything obvious I'm guessing a rod bearing. lifter? piston ring? piston slap or a rod knock. I cut open the oil filter and I have small ferrous metal in the filter not a lot but some. Anyway why do you all think it is?
__________________
JOHNNY P Currently own 90 ZR-1 #845 DRM 500 engine package 90 #226 Parts car Hit me up if you need anything. Last edited by phrogs; 03-15-2024 at 04:23 PM. |
![]() |
![]() |
![]() |
#2 |
![]() Join Date: Apr 2007
Location: Northern VA
Posts: 2,653
|
![]()
__________________
Phil Wasinger 1994 Torch Red ZR-1 WAZOO Member George Braml Intake |
![]() |
![]() |
![]() |
#3 |
![]() Join Date: Jul 2017
Location: West Chester, PA
Posts: 378
|
![]()
Seems to be one "tick" per engine revolution (i counted 15 ticks in about 2 sec at idle).
__________________
1990 Black/Black ZR-1 #1155 1993 White/Red coupe (Regrettably sold) ![]() |
![]() |
![]() |
![]() |
#4 |
Join Date: Mar 2024
Location: Northeast
Posts: 43
|
![]()
The ticking noise sounds sort of like an exhaust leak. Does it go away when it warms up?
|
![]() |
![]() |
![]() |
#5 |
![]() Join Date: Mar 2007
Location: Crystal Lake, IL
Posts: 7,194
|
![]()
when my 90 was stock it made that noise 90-966, and when I put a different engine in it made the same noise.... 90-702 motor. There were some cam noise issues on 90s, I never figured it out on my car.... and it never showed knock.
__________________
LGAFF 90 #966-150K miles-sold 92 #234-sold 1987 Callaway TT #17 1991 ZR-1 #1359 |
![]() |
![]() |
![]() |
#6 |
![]() Join Date: Mar 2007
Location: Crystal Lake, IL
Posts: 7,194
|
![]()
Noise also came and went w/weather...
__________________
LGAFF 90 #966-150K miles-sold 92 #234-sold 1987 Callaway TT #17 1991 ZR-1 #1359 |
![]() |
![]() |
![]() |
#7 |
![]() Join Date: Jul 2004
Location: Kalamazoo MI
Posts: 1,764
|
![]()
well I found my knock sensor plug melted still have to check if that may be part of it.
__________________
JOHNNY P Currently own 90 ZR-1 #845 DRM 500 engine package 90 #226 Parts car Hit me up if you need anything. |
![]() |
![]() |
![]() |
#8 |
![]() Join Date: Apr 2007
Location: Lake Bluff, IL
Posts: 2,065
|
![]()
Johnny, maybe it just as simple as this... --Bob
__________________
2016 Long Beach Red Z06 #10281 "POPS Z" 1995 Polo Green #409 "WARP TEN"--Haibeck 350/510 package, 4.10s, Hurst, Stock Exhaust with QTP Cutouts --Sold but still running strong 1993 Quasar Blue #161 "HIL KING" --Sold but still running strong, now with more than 120,000 miles 1967 Marlboro Maroon/Saddle Corvette Coupe 300 hp/4-spd --Sold a long time ago ZR-1 Net Registry Founding Member #95 NCM Lifetime Member Favorite Quote--Attributed to Mickey Thompson: "Too Much Horsepower is Almost Enough" |
![]() |
![]() |
![]() |
#9 |
![]() Join Date: Jul 2004
Location: Kalamazoo MI
Posts: 1,764
|
![]() **** I wish. Lee mentioned a little thicker oil so I'm going to try that and see if it changes. I needed to fix a rear main seal leak and that pan gasket as well so almost ready to fire it up. So we'll see.
__________________
JOHNNY P Currently own 90 ZR-1 #845 DRM 500 engine package 90 #226 Parts car Hit me up if you need anything. |
![]() |
![]() |
![]() |
#10 |
![]() Join Date: Jan 2024
Location: Boston, MA
Posts: 166
|
![]()
Totally different engine, but my L98 had a loose valve guide sound very similar to that clicking. I kept adjusting my rockers thinking one was loose.
__________________
1987: Z51 Coupe, Z51, 4+3, Yellow / Graphite 1994: ZR-1 #150, Admiral Blue / Black 2015: Z06 Coupe, Z07, M7, Arctic White / Red |
![]() |
![]() |
![]() |
|
|