|
|
|
10-04-2005
|
#1 |
 Join Date: Aug 2005
Location: NY
Posts: 143
|
photo and dimension of damper
I need a front, side and rear photo of the LT5 torsional damper.
I also need the inside diameter of the shaft area or outside diameter of the crankshaft where they mount together.
__________________
Mike 427 cu in LT5 [URL="http://zr1mk.weebly.com"]http://zr1mk.weebly.com[/URL] |
|
|
|
10-31-2005
|
#2 |
|
Join Date: Aug 2005
Location: NY
Posts: 143
|
Re: photo and dimension of damper
I received the pictures I was looking for. Next question.
Did the World Challenge ZR1s use the stock engine torsional damper or an aftermarket unit?
__________________
Mike 427 cu in LT5 [URL="http://zr1mk.weebly.com"]http://zr1mk.weebly.com[/URL] |
|
|
|
|
10-31-2005
|
#3 |
|
Guest
Posts: n/a
|
Re: photo and dimension of damper
Didn't think there were any WC ZR-1's. Just L98 cars.
|
|
|
|
11-01-2005
|
#4 |
|
Join Date: Aug 2005
Location: NY
Posts: 143
|
Re: photo and dimension of damper
http://www.speedvisionwc.com/2001/rat/gt-qual2.html
http://zr1netregistry.com/ZR1_racingpictures.htm
__________________
Mike 427 cu in LT5 [URL="http://zr1mk.weebly.com"]http://zr1mk.weebly.com[/URL] |
|
|
|
|
11-01-2005
|
#5 |
Join Date: Dec 2003
Location: Sacramento, CA
Posts: 224
|
Re: photo and dimension of damper
What the junk,... I posted in this thread earlier... where'd it go?
 E-gnomes.
__________________
"Mr. President, we must not allowwww... a mine shaft gap!!" -General Buck Turgidson 1994 ZR1 - White on Black |
|
|
|
|
11-01-2005
|
#6 |
|
Join Date: Aug 2005
Location: NY
Posts: 143
|
Re: photo and dimension of damper
I know you did too because I read you message.
So whats going on?
__________________
Mike 427 cu in LT5 [URL="http://zr1mk.weebly.com"]http://zr1mk.weebly.com[/URL] |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
