Q: Removing 2ndary shafts? - ZR-1 Net Registry Forums

Paul Workman · 04-12-2009

What is the "trick" (besides getting a bigger hammer) to pulling the secondary throttle plate shafts out?

I don't want to booger 'em up (if possible), just remove 'em. Any pointers out there?

Thanks in advance.

P.

Pete · 04-12-2009

Socket,washer over the shaft use the screw to pull the shaft out.
Make sure the socket is bigger then the bearing.

Pete

Paul Workman · 04-12-2009

Quote:

Originally Posted by Pete

Socket,washer over the shaft use the screw to pull the shaft out.
Make sure the socket is bigger then the bearing.

Pete

A-Ha!

Thanks Pete!

P.

04-12-2009	#1
Paul Workman Join Date: Nov 2007 Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri Posts: 6,493	Q: Removing 2ndary shafts? What is the "trick" (besides getting a bigger hammer) to pulling the secondary throttle plate shafts out? I don't want to booger 'em up (if possible), just remove 'em. Any pointers out there? Thanks in advance. P.

04-12-2009	#2
Pete Join Date: Dec 2003 Location: Chicagoland,IL Posts: 2,679	Re: Q: Removing 2ndary shafts? Socket,washer over the shaft use the screw to pull the shaft out. Make sure the socket is bigger then the bearing. Pete __________________ '91 #1635 PoloGreen 350 LT5 11.09 @ 129.27 11.04 @ 128.86 474RWHP 400RWTQ http://www.youtube.com/watch?v=SFNFOhGGlR4 http://www.youtube.com/watch?v=ZlRIOMwaDYY https://sites.google.com/site/peteszr1garage

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode