Vegas in September

[4DSZR1]

I'm just curious......Who's planning on going to the PNW Gathering in Las Vegas?

I'll be there. If I'm bringing a car I may haul it down. But I may be flying.

[tf95ZR1]

Originally Posted by Jeffvette

I'll be there.

Jeff promised to bring some of the honeys in his avatar.

I'll be there........

[GOLDCYLON]

Originally Posted by tf95ZR1

Jeff promised to bring some of the honeys in his avatar.

I'll be there........

Hmmm I heard the real story is Jeff has all those honeys and has no time to show up.

[cuisinartvette]

I should be there this year.

[PhillipsLT5]

I will be there again
Goldcylon, you better be going

[GOLDCYLON]

Will need to check in with Household 6!!!! BTW

PS P&P and PC job is done. Awaiting two parts before the big reveal. Taking her to the Dyno tomorrow.

[tf95ZR1]

Originally Posted by GOLDCYLON

P&P and PC job is done. Awaiting two parts before the big reveal. Taking her to the Dyno tomorrow.

Pics Pics!

[cuisinartvette]

Originally Posted by GOLDCYLON

Will need to check in with Household 6!!!! BTW

PS P&P and PC job is done. Awaiting two parts before the big reveal. Taking her to the Dyno tomorrow.

Awesome! I was hoping to get some porting and headers done before this years event but it will have to wait til winter.
Oh well, someone has to be the slow guy

[GOLDCYLON]

Originally Posted by cuisinartvette

Awesome! I was hoping to get some porting and headers done before this years event but it will have to wait til winter.
Oh well, someone has to be the slow guy

It took 4 months of planning and parts chasing. 3 weeks of assembly/disassembly and the support and counsel of Jeffvette, the ZF.Doc and Carter200 with some special engraving. Zethco hooked me up with the stainless bolts and part numbers. I am awaiting the camcover emblems for the reveal.

Heres a talley of what was done!!!

Porting and polishing of entire top end to include plenum, air horn and injector housings. Entire top end from Throttle shield cover to MAP sensor bracket was powercoated in Silver Metallic Paint with red and black lettering. All work done by Jeffvette.

Diassembly and assembly was completed by Bill B the ZF.Doc and his trusty helper. I chose to replace the following during the tear down.

Removed Original Injectors and replaced with RC SL4-205s (all the originals were rusted BTW)
New Plugs, Iridium of course
New Wires, Delco of course
4 New Delco Coil Packs
1 New Starter
2 New PCV Valves and PCV tubing
1 New MAP sensor but dammit I bought the wrong part (lol)

Carter provided Machined LT-5 Coolant Pipes, LT-5 TPI Cover and a ZR-1 Billet Oil Filter cover

Zethco hooked me up with Macallister for all the stainless hardware

Pics to follow, If I can get a kitchen pass after pulling off all these mods with Household 6 I will be in LV for at least a few days.

All these folks made this happen and the Permagrin continues to get wider. It all about the car and the people folks!! Goldcylon