ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 Technical Postings

Reply
 
Thread Tools Display Modes
Old 06-26-2007   #1
tenedios
 
Join Date: Sep 2006
Posts: 9
Default Upgrading the wattage in driving lamps

Has anyone upgraded the stock bulb of 34 watts in the driving lamps?
Thanks for your time. George
tenedios is offline   Reply With Quote
Old 06-26-2007   #2
zr-1assassin
 
zr-1assassin's Avatar
 
Join Date: Feb 2007
Location: saint joseph,mo.
Posts: 279
Default Re: Upgrading the wattage in driving lamps

i dont know either but would sure like to. i always use just the driving lights at night.....gives it a much meaner lower look. and i have thought about getting a little brighter lights so i dont have to worry about the po-po pulling me over.
zr-1assassin is offline   Reply With Quote
Old 06-27-2007   #3
jonszr1
 
jonszr1's Avatar
 
Join Date: Sep 2006
Location: lone pine and mammoth lakes
Posts: 1,407
Default Re: Upgrading the wattage in driving lamps

you can put in 50wat driving lights plus you can adjust them to project out farther the stk bulb is part number 880 the 50 watt is 885. you must though put a 15amp fuse in place of the 10 amp fuse . i drive around with the driving lights on all the time since i have changed over and readjusted them. it really looks cool now
jonszr1 is offline   Reply With Quote
Old 06-27-2007   #4
gbrtng
 
gbrtng's Avatar
 
Join Date: Feb 2006
Location: San Antonio area
Posts: 1,179
Default Re: Upgrading the wattage in driving lamps

Quote:
Originally Posted by jonszr1
you can put in 50wat driving lights plus you can adjust them to project out farther the stk bulb is part number 880 the 50 watt is 885. you must though put a 15amp fuse in place of the 10 amp fuse . i drive around with the driving lights on all the time since i have changed over and readjusted them. it really looks cool now
A 15 amp fuse in place of a 10 amp is like the old penny in the fusebox
trick. The wiring was engineered for the original current load and increasing the current "might" be OK, but a quick check of the wiring to make sure it's not getting too warm is in order. Or check the shop manual wiring diagrams to see what gauge wire is used. It might be adequate but
then again ...

Glenn
91-1341
MSEE Purdue 1967
gbrtng is offline   Reply With Quote
Old 06-29-2007   #5
jonszr1
 
jonszr1's Avatar
 
Join Date: Sep 2006
Location: lone pine and mammoth lakes
Posts: 1,407
Default Re: Upgrading the wattage in driving lamps

Quote:
Originally Posted by gbrtng
A 15 amp fuse in place of a 10 amp is like the old penny in the fusebox
trick. The wiring was engineered for the original current load and increasing the current "might" be OK, but a quick check of the wiring to make sure it's not getting too warm is in order. Or check the shop manual wiring diagrams to see what gauge wire is used. It might be adequate but
then again ...

Glenn
91-1341
MSEE Purdue 1967
maybe your playing devils advocate .but i can assure you that it was well researched it has even come out oin a little book called 101 corvette projects. it also an engeneering faCT TO OVERSIZE THE WIRING to take double the load to take the powerspike when a fuse blows
jonszr1 is offline   Reply With Quote
Old 06-27-2007   #6
zr-1assassin
 
zr-1assassin's Avatar
 
Join Date: Feb 2007
Location: saint joseph,mo.
Posts: 279
Default Re: Upgrading the wattage in driving lamps

Quote:
Originally Posted by jonszr1
you can put in 50wat driving lights plus you can adjust them to project out farther the stk bulb is part number 880 the 50 watt is 885. you must though put a 15amp fuse in place of the 10 amp fuse . i drive around with the driving lights on all the time since i have changed over and readjusted them. it really looks cool now
thanks for the infoyou didn't have any troubles with changing the fuse to a larger size did ya? meltdown is not a good thing
zr-1assassin is offline   Reply With Quote
Old 06-28-2007   #7
jonszr1
 
jonszr1's Avatar
 
Join Date: Sep 2006
Location: lone pine and mammoth lakes
Posts: 1,407
Default Re: Upgrading the wattage in driving lamps

no the fuse is exactly the same just has a higher amp rating . the wire is no problem. it can handle twice the amps before being a problem. . remember you are only raising the fuse 5 amps. i have had this change in effect for 2 years with no problems.
jonszr1 is offline   Reply With Quote
Old 06-28-2007   #8
zr-1assassin
 
zr-1assassin's Avatar
 
Join Date: Feb 2007
Location: saint joseph,mo.
Posts: 279
Default Re: Upgrading the wattage in driving lamps

Quote:
Originally Posted by jonszr1
no the fuse is exactly the same just has a higher amp rating . the wire is no problem. it can handle twice the amps before being a problem. . remember you are only raising the fuse 5 amps. i have had this change in effect for 2 years with no problems.
next question...you said part#885. is that acdelco or what kind of lights? thanks again
zr-1assassin is offline   Reply With Quote
Old 06-28-2007   #9
Ccmano
 
Ccmano's Avatar
 
Join Date: Jun 2006
Location: Sparks, NV
Posts: 2,852
Default Re: Upgrading the wattage in driving lamps

Quote:
Originally Posted by jonszr1
you can put in 50wat driving lights plus you can adjust them to project out farther the stk bulb is part number 880 the 50 watt is 885. you must though put a 15amp fuse in place of the 10 amp fuse . i drive around with the driving lights on all the time since i have changed over and readjusted them. it really looks cool now
Did mine, works and looks great... ....a very simple mod that is very effective. It's written up in "101 Projects for your Vette" book, that's where I found it.
Hans
__________________
90'ZR-1 #1461 Red/Black
Ported Intake, Degreed Cams, OBX Headers & Exhaust, Fidanza FW, Secondary Delete, Custom tune, C6 GS Wheels. Sold
08 C6 Z51 Crystal Red Metallic Sold Vararam Intake, Tune, Sold
05 C6 Z51 Red/Black Sold
90'ZR-1 #1723 Black/Gray Sold but not forgotten
91' Z51 L98 White Vert. My First, you always remember your first. Sold.
Ccmano is offline   Reply With Quote
Old 06-28-2007   #10
zr-1assassin
 
zr-1assassin's Avatar
 
Join Date: Feb 2007
Location: saint joseph,mo.
Posts: 279
Default Re: Upgrading the wattage in driving lamps

Quote:
Originally Posted by Ccmano
Did mine, works and looks great... ....a very simple mod that is very effective. It's written up in "101 Projects for your Vette" book, that's where I found it.
Hans
hey Ccmano, what other tricks have you found in that book to be great? i need some little projects
zr-1assassin is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:07 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020