|
|
|
11-02-2017
|
#1 |
 
Join Date: Jun 2006
Location: Sparks, NV
Posts: 2,852
|
Input Shaft wear?
What do you guys make of this input shaft tip... After I pulled the trans I noticed that the pilot bearing (a roller bearing replacement) was installed slightly crooked. I measured a variance in insertion depth from one side to the other of .023 in. Here’s how the input shaft looks. Remember it has 180k miles on it. It is grenerally smooth when I run my finger nail over it.
H  
__________________
90'ZR-1 #1461 Red/Black Ported Intake, Degreed Cams, OBX Headers & Exhaust, Fidanza FW, Secondary Delete, Custom tune, C6 GS Wheels. Sold 08 C6 Z51 Crystal Red Metallic Sold Vararam Intake, Tune, Sold 05 C6 Z51 Red/Black Sold 90'ZR-1 #1723 Black/Gray Sold but not forgotten 91' Z51 L98 White Vert. My First, you always remember your first. Sold. |
|
|
|
11-02-2017
|
#2 |
Join Date: Apr 2007
Location: Northern VA
Posts: 2,661
|
Re: Input Shaft wear?
Crocus Cloth will clean it up just fine.
__________________
Phil Wasinger 1994 Torch Red ZR-1 WAZOO Member George Braml Intake |
|
|
|
|
11-02-2017
|
#3 | |
|
Join Date: Jun 2006
Location: Sparks, NV
Posts: 2,852
|
Re: Input Shaft wear?
Quote:
H
__________________
90'ZR-1 #1461 Red/Black Ported Intake, Degreed Cams, OBX Headers & Exhaust, Fidanza FW, Secondary Delete, Custom tune, C6 GS Wheels. Sold 08 C6 Z51 Crystal Red Metallic Sold Vararam Intake, Tune, Sold 05 C6 Z51 Red/Black Sold 90'ZR-1 #1723 Black/Gray Sold but not forgotten 91' Z51 L98 White Vert. My First, you always remember your first. Sold. |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
