|
11-27-2007
|
#1 |
|
Join Date: Oct 2007
Location: lone pine and mammoth lakes ca.
Posts: 544
|
6 way switchproblems
the seat awitch that is on the console is acting up. i can switch the power and ground switch and getit to move one way i put it back and it moves the other way. ie moves forward switch the wires it moves back but it wont move both ways from either position . anyone have this happen? is the switch bad ?
|
|
|
|
11-27-2007
|
#2 | |
 
Join Date: Feb 2006
Location: San Antonio area
Posts: 1,183
|
Re: 6 way switchproblems
Quote:
There are three motors that move the seat: a.) forward and backward b.) front of seat up and down c.) rear of seat up and down So what is really happening?
__________________
“Buy the best example of what you want, and pay whatever it takes. That way, you cry only once.” ~ Bruce Meyer |
|
|
|
|
|
11-27-2007
|
#3 |
|
Join Date: Oct 2007
Location: lone pine and mammoth lakes ca.
Posts: 544
|
Re: 6 way switchproblems
ok heres the deal power wire and ground wire one way it goes up and forward reverse the power and ground it goes back and down . but will only do those functons could i have switched connections at the seat?
|
|
|
|
|
11-27-2007
|
#4 | |
|
Join Date: Feb 2006
Location: San Antonio area
Posts: 1,183
|
Re: 6 way switchproblems
Quote:
Sliding the control forward/rearward operates the center motor to run the seat forward and backward. Pushing the front end of the control toward/away from the center of the car runs the front motor "up/down". Same for the rear end of the control. And you can push the control bar toward/away from the center of the car to run both front and rear motors at the same time. The seat connector is keyed so you can't make a mistake. Refer to section 8A-140 in the service manual for wire colors and the troubleshooting guide. Does the RH seat work OK?
__________________
“Buy the best example of what you want, and pay whatever it takes. That way, you cry only once.” ~ Bruce Meyer |
|
|
|
|
|
11-27-2007
|
#5 |
|
Join Date: Oct 2007
Location: lone pine and mammoth lakes ca.
Posts: 544
|
Re: 6 way switchproblems
first off thankyou so much for taking the time to help me . yes the right side works fine. i would guess the switch might be bad . my thinking is that the switch wont reverse the motors that it only works one way . do you think that is correct .I do have 2 zr1s is it hard to get the wires up out of the console area. guess i would have to remove the seat ? I guess i could just switch the wires everytime i want to move a certain way (just kiddin)
|
|
|
|
 |
|
|
Linear Mode
