|
10-19-2014
|
#1 |
 Join Date: Nov 2011
Location: Dunbarton NH
Posts: 7,561
|
headlight bushings
So the drivers side was straight forward enough, but the passengers side, I cannot get the gear out of the case. On the passengers side, the pinned end of the shaft goes through the cover I removed, the shaft does not penatrate the other side of the cast. The shaft and gear won't come out. Help.
|
|
|
|
10-19-2014
|
#2 |
|
Join Date: Nov 2011
Location: Dunbarton NH
Posts: 7,561
|
Re: headlight bushings
Got it.
|
|
|
|
|
10-19-2014
|
#3 | |
 
Join Date: Aug 2009
Location: South Dakota/California
Posts: 3,815
|
Re: headlight bushings
Quote:
 What happened and how did you fix it? 
__________________
Clickable links On Iphone Touchable Links -Solutions- LT5 Modifications/Rebuild Tricks Low Mileage ZR-1 Restoration 1990 Corvette (L98) Modifications LT5 Eliminated Systems LT5 Added Systems LT5/ZR-1 Fluids 1995 LT5 SPECIFIC TOP END REBUILD TRICKS |
|
|
|
|
|
10-19-2014
|
#4 |
|
Join Date: Nov 2011
Location: Dunbarton NH
Posts: 7,561
|
Re: headlight bushings
The large plastic gear has a shelf? on the side of the gear. On the drivers side the shelf is on our side of the worm gear on the motor. On the passengers side, the shelf is behind the worm gear. I pitched the large gear as much as possible, to twist the shelf out from behind the worm gear. Plus I put a drift pin through the hole in the shaft and pulled hard.
None of the youtube videos show the passengers side.There are also three spacers that a lot of the videos don't address. |
|
|
|
 |
|
|
Linear Mode
