![]() |
#1 |
![]() Join Date: Aug 2005
Location: NY
Posts: 142
|
![]()
I need a front, side and rear photo of the LT5 torsional damper.
I also need the inside diameter of the shaft area or outside diameter of the crankshaft where they mount together. |
![]() |
![]() |
![]() |
#2 |
![]() Join Date: Aug 2005
Location: NY
Posts: 142
|
![]()
I received the pictures I was looking for. Next question.
Did the World Challenge ZR1s use the stock engine torsional damper or an aftermarket unit? |
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
![]()
Didn't think there were any WC ZR-1's. Just L98 cars.
|
![]() |
![]() |
#4 |
![]() Join Date: Aug 2005
Location: NY
Posts: 142
|
![]() |
![]() |
![]() |
![]() |
#5 |
Join Date: Dec 2003
Location: Sacramento, CA
Posts: 220
|
![]()
What the junk,... I posted in this thread earlier... where'd it go?
![]() E-gnomes. |
![]() |
![]() |
![]() |
#6 |
![]() Join Date: Aug 2005
Location: NY
Posts: 142
|
![]()
I know you did too because I read you message.
So whats going on? |
![]() |
![]() |
![]() |
#7 |
Join Date: Dec 2003
Location: Sacramento, CA
Posts: 220
|
![]()
E-gnomes I tells ya. Little short fat buggers with peculiar hats that run around at night screwin shyt up all over the internet. I think Wadsworth is their leader.
![]() Last edited by Patton; 11-02-2005 at 11:29 AM. |
![]() |
![]() |
![]() |
|
|