Re: Kent-Moore J 41009 Can Tensioner Unloader Tool
Quote:
Originally Posted by Jagdpanzer
Craig kindly borrowed me his tensioner release tool and the results are on the left:
After discussing with Craig and reading the MH write up on cam timing http://www.zr1specialist.com/HAT%20W..._camshafts.htm I elected to increase the pin diameter to just under the plug hole size in the tensioner housing. The ring is from key chain I had laying around.
Thanks Craig for helping me out.
Phil |
Phil,
You're more than welcome and thanks for the keyring. I sent the instructions from the tensioner and if you need to redesign or something after testing, no rush to return.
Craig
__________________
Craig
"ZR-1 NO KA 'OI"
"ZR-1 ICHIBAN"
1995 #228 Black/Black with Dunn Heads
ZR-1 owner since September 2003
ZR-1 Net Registry Founding Member #0074
NCM Lifetime Member #2048
|