ZR-1 Net Registry Forums - View Single Post - Plenum Pull

gbmidyear66 · 05-12-2010

I used Blue loctite on the fuel rails and the fuel line connection. The IH bolts and breather bolts needed minimal tightening - so I let them be.

I am thinking I may try to re-coat my visible bolts which are showing some rust (or maybe go to SS) - so will not loctite them

Checked the new injectors for leaks - they are good.

I've got my tie wrap selection ready. I was going to use silicon for any loose fittings, + tie wrap - is hair spray better than slicone?

05-12-2010	#3
gbmidyear66 Join Date: Feb 2008 Location: Vancouver, BC Posts: 251	Re: Plenum Pull - Anything Else I should do? I used Blue loctite on the fuel rails and the fuel line connection. The IH bolts and breather bolts needed minimal tightening - so I let them be. I am thinking I may try to re-coat my visible bolts which are showing some rust (or maybe go to SS) - so will not loctite them Checked the new injectors for leaks - they are good. I've got my tie wrap selection ready. I was going to use silicon for any loose fittings, + tie wrap - is hair spray better than slicone?