ZR-1 Net Registry Forums - View Single Post

bdw18_123 · 01-16-2010

I've got Haibeck's timing chain article printed out and in my LT5 service manual. While I can read it, the scan quality is very poor, would be nice to have a higher resolution version.

I've gotta do some serious studying on this procedure when I get ready to reassemble my '90 LT5. Also have to make the special tools that I can and buy the ones I can't. Will definitely be a learning experience, but I know I can do it.

I'm planning on printing out this degree wheel that I found on the internet (can't remember where) and mounting it on cardboard or thin plastic. Will it work ok to use this on the LT5? (I reduced the size for posting, the one I have is much larger)

01-16-2010	#4
bdw18_123 Join Date: Apr 2009 Location: Prather, CA Posts: 804	Re: cam timing I've got Haibeck's timing chain article printed out and in my LT5 service manual. While I can read it, the scan quality is very poor, would be nice to have a higher resolution version. I've gotta do some serious studying on this procedure when I get ready to reassemble my '90 LT5. Also have to make the special tools that I can and buy the ones I can't. Will definitely be a learning experience, but I know I can do it. I'm planning on printing out this degree wheel that I found on the internet (can't remember where) and mounting it on cardboard or thin plastic. Will it work ok to use this on the LT5? (I reduced the size for posting, the one I have is much larger) Last edited by bdw18_123; 01-16-2010 at 05:42 PM.