Quote:
Originally Posted by ZZZZZR1
Congrats!!! I didn't notice in earlier posts, but did you take off the wheel wells?
Everything fit well? No issues?
David |
Yes...removed wheel wells completely which took all of 10 minutes. NO issues at all....headers cleared everything easily....I modified the original CAT heat shields and put back in place to keep heat away from the 02 sensor wiring. Getting those original CATS out of the way made a BIG difference. I did not install CATS with SW so just have a short straight 3" tube section where the CATS were
It actually took a bit longer than 15 minutes (It took about an hour to get to the passenger side 02 sensor plug)
It is a very clean installation with the Air Induction system gone out of the way.
I am guessing Stainless Works did some home work in the last year and solved ALL the issues.
I would say the original stock exhaust system was ten times harder to remove than it was to install the SW ZR1CORVOR headers and SW ZR1CHAMSW 3 inch exhaust system