Re: DRM Chip
Very simple indead. Remove the negative battery cable (8mm). Remove four 10mm nuts on the ECM just above the battery and "flip" in gently over on the windshield. There will be four screw holding on a plate on the bottom of the ECM (been a while--they are smaller). The screws have a rubber washer that you must be careful not to lose or damage. Pry off the cover gently. Press the outside prongs on the chip and it will release. Reverse and you're done.
Airbox: Remove the two outboard hold down screws. Loosen the airduct. Pull up on the back/top of the airbox. Exchange and tighten the middle hold down screw. Put the front/bottom of the airbox in. Pick up the front of the airduct and replace.
Ted
|