ZR-1 Net Registry Forums - View Single Post - U-joints done

rhipsher · 01-14-2009

I think I found the issues. One bad passenger side rear wheel bearing. And two bad rear shocks. When I jacked up the rear end and sit it back down it sat 2" higher. Then drove around the block it sat 2" lower again. And when it sits that low it causes the half shafts to be at a steeper angle which is not good. And I already know I need new front tires and probably a good alignment.

01-14-2009	#5
rhipsher Join Date: Aug 2008 Location: Houston, TX Posts: 2,314	Re: U-joints done I think I found the issues. One bad passenger side rear wheel bearing. And two bad rear shocks. When I jacked up the rear end and sit it back down it sat 2" higher. Then drove around the block it sat 2" lower again. And when it sits that low it causes the half shafts to be at a steeper angle which is not good. And I already know I need new front tires and probably a good alignment.