ZR-1 Net Registry Forums - View Single Post

Aurora40 · 01-07-2009

What would prevent air from getting in when you remove the adapters to re-install the brake lines?

I didn't remove my m/c from the car. I followed the DRM instructions and picked the proportioning valve out vs beating it against some wood like the FSM suggests.

Thanks for the feedback everyone. I think I will just drive the car (tomorrow should be a nicer day) and see how it feels. If it's not good then I'll bleed all the calipers again.

01-07-2009	#8
Aurora40 Join Date: May 2005 Location: Leesburg, VA Posts: 2,704	Re: Bleeding master cylinder question... What would prevent air from getting in when you remove the adapters to re-install the brake lines? I didn't remove my m/c from the car. I followed the DRM instructions and picked the proportioning valve out vs beating it against some wood like the FSM suggests. Thanks for the feedback everyone. I think I will just drive the car (tomorrow should be a nicer day) and see how it feels. If it's not good then I'll bleed all the calipers again.