ZR-1 Net Registry Forums - View Single Post

03-29-2008

Pete ,
this cost is fair for that system!
i would pay for this BUT in same time this will not give me much gain over well fully port factory LT5 engine, as i spoke in many things to the Engineer manager of KINSLER FUEL INJ. last year, so they fabricate manifold( but without plenum,same as their system which gives Big Hp gain, and also the fuel rail would be outside, but the truth this thing would not put more power over the Oval ported Lt5 intake sytem!!

Jmho
The LT5 is one of the finest manifold have been produced...and still will be.

I post before about this project in Zr1 net forum.

i wish if you take that sytem and compare it to Oval ported Lt5, and give us the results. Good luck

03-29-2008	#25
HADI-ZR1 Guest Posts: n/a	Re: Bada$$ Intake Pete , this cost is fair for that system! i would pay for this BUT in same time this will not give me much gain over well fully port factory LT5 engine, as i spoke in many things to the Engineer manager of KINSLER FUEL INJ. last year, so they fabricate manifold( but without plenum,same as their system which gives Big Hp gain, and also the fuel rail would be outside, but the truth this thing would not put more power over the Oval ported Lt5 intake sytem!! Jmho The LT5 is one of the finest manifold have been produced...and still will be. I post before about this project in Zr1 net forum. i wish if you take that sytem and compare it to Oval ported Lt5, and give us the results. Good luck Last edited by HADI-ZR1; 03-29-2008 at 02:14 PM.