Re: Fires then dies. HELP
UPDATE:
After a phone call with Marc Haibeck, he suggested that I disconnect the harness from the cam sensor to the ECU. I didn?t think this would achieve anything due to, knowing that the engine would/should run without the cam sensor functioning. BUT, with the harness connected, and the sensor faulty, I can only assume that it was sending a bad signal to the ECU. Once I DISCONNECTED the harness, it fired up and ran as per normal. BINGO. I took it for run yesterday, to a car show approximately 30km away and it ran perfectly with the harness disconnected.
I borrowed a cam sensor off a friend and fitted that in today, and with the harness CONNECTED as it should be, it started up and ran perfectly again.
I can only conclude that the cam sensor was faulty and caused my initial problem.
All the car show & shine events are starting back up, now that our weather here in OZ is nice and getting better. So good timing. I?m happy as??.😁
Cheers,
Russell 🇦🇺
|