Quote:
Originally Posted by Corvette95
I saw that. I went past 7k on each pull and Batee just calibrated my tach, I do wonder if I should have pushed it morel
|
After completing the "500 package" (510ish) I had Marc bump my rev limiter to 7500 b/c I was hitting the 7100 limiter 100 yards before I crossed the traps in the quarter mile. I'm thinking you may have that same issue too, if quarter mile runs are in the plan!
My scanner has a tach readout, so I calibrated my own tach - built a resistor bridge to correct the stock part that deteriorates over time.
Batee now offers the replacement part for a "DIY" calibration, if so inclined. (Pretty easy to do if you have the iron, etc., to remove the solder and replace it with the new part.)