Quote:
Originally Posted by jss06c6
Not quite sure what your question is.
The dust boot can't realistically be removed without pulling the transmission..
Beam plate installation is easily done without removing anything except the C-Beam bolts.
What "housing" are you trying to remove?
Sent from my SM-G950U using ZR-1 Net Registry mobile app |
Well, your confusion is my confusion. This is in the C-Beam solutions thread about C-Beam removal. I have the C-Beam out, I am likely going to pull the transmission after a test run with new motor mounts and C-Beam plates, my question is really what am I looking at in this photo, why would it say the seal got installed too early? If I do pull my transmission I take it this seal is in the rear transmission extension housing...or is this seal something else? It just has me confused as I like to have the order of things in my mind before I do them, if I need this seal, when would I install (with trans in or out). Thanks
The FSM says nothing about this in the R/R trans section. Also this does not look like the press in rear oil seal.