ZR-1 Net Registry Forums - View Single Post

Perry Mitchell · 06-22-2020

I used a 1/4'' threaded rod and flattened one end using a hammer then drilled a hole in it for the linkage pin to slip into. Loctite on the inboard nut might be a good idea. I used a nylon lock nut on the outside.

06-22-2020	#3
Perry Mitchell Join Date: Nov 2018 Location: Washington Posts: 98	Re: Eliminating the secondaries I used a 1/4'' threaded rod and flattened one end using a hammer then drilled a hole in it for the linkage pin to slip into. Loctite on the inboard nut might be a good idea. I used a nylon lock nut on the outside.