[wutanec]

So I finally took the plenum off tonight. The process has been less painful than expected but I had a couple of oopsie moments. I will tackle IH tomorrow and see how that goes.

Now here are my newbie mistakes.

* While removing the connectors in the rear bottom side of the plenum, I broke one of the clips while trying to pull it out........which connector is it and is there a way to purchase a pig tail version?

* While pulling wires off of injectors, I did not realize there were little orange gaskets to the connectors, I lost one of them. I just ordered a few from Jerry's but now I am paranoid that it might have fallen into one of the ports....will I be able to see it once I take the IH's off? if not, I assume it will kiss the engine good bye yes? lol

* I tried to pull off the injectors..It seemed like the secondaries are loose but the primaries would not budge...any tips on how to remove those suckers?

Thank you.