Re: Pulley Failure
Quote:
Originally Posted by Dynomite
Did you modify the Tensioner such that the pulley inner hub was not in contact with the tensioner at any place? Take a close up photo of the Aluminum Pulley belt surface. Also a close up photo of the failed surface.
Was the Pulley Bearing Snap Ring on the outside or toward the engine?
|
I'll have to take a look at that once I get the tensioner out. I don't recall any modification being necessary. The pulley has multiple holes in it, all around, so obviously it was turning some and then locking up at times.
__________________
Robert
ZR-1 Net Registry Oregon State Director
91 ZR-1 #431 Black/Black LPE 368
Last edited by Locobob; 05-26-2019 at 03:13 PM.
|