ZR-1 Net Registry Forums - View Single Post

5ABI VT · 10-18-2018

Definitely a sprung hub it will cut down on some noise. My suggestion, is oem pressure plate and a centerforce dual friction disc or a Centerforce clutch setup with pressure plate and disc (If I remember right the CF pp has a higher clamp load than the LT5 pp - which in turn is higher than the LT4/LT1). On my car it only rattled a bit when very hot at idle. Wasn't noticeable I have many idle videos to show the sound. But under load there's definitely gear rattle if say you're loading the motor ie using a higher gear or two and/or shifting early.

10-18-2018	#15
5ABI VT Join Date: Jun 2013 Location: Toronto Posts: 780	Re: Aluminum flywheel.... new clutch? Definitely a sprung hub it will cut down on some noise. My suggestion, is oem pressure plate and a centerforce dual friction disc or a Centerforce clutch setup with pressure plate and disc (If I remember right the CF pp has a higher clamp load than the LT5 pp - which in turn is higher than the LT4/LT1). On my car it only rattled a bit when very hot at idle. Wasn't noticeable I have many idle videos to show the sound. But under load there's definitely gear rattle if say you're loading the motor ie using a higher gear or two and/or shifting early.