ZR-1 Net Registry Forums - View Single Post - Fuel sending unit replacement for an accurate reading

Demps · 09-20-2018

So...I know a guy that...

When you put the sender [back] in the float can hang up. First, while getting it all in through the tank opening. Second, once in the tank IF one were to reach in to position the assembly it is possible to push against the float arm.

All of this is assuming the range of measurement is there. There are some posts here or CF (check Cliff's solutions) on how to measure resistance. I'm also a K.I.S.S. follower, & would slightly bend it (float) up if the sender has been removed lately.

Ted

09-20-2018	#10
Demps Join Date: Jan 2006 Location: Niceville Posts: 1,000	Re: Fuel sending unit replacement for an accurate reading So...I know a guy that... When you put the sender [back] in the float can hang up. First, while getting it all in through the tank opening. Second, once in the tank IF one were to reach in to position the assembly it is possible to push against the float arm. All of this is assuming the range of measurement is there. There are some posts here or CF (check Cliff's solutions) on how to measure resistance. I'm also a K.I.S.S. follower, & would slightly bend it (float) up if the sender has been removed lately. Ted