Won't have the section 8A booklet until next Tuesday nite.
Test light connected from Negative to Purple wire, key on Start position, nothing , no power to test light.
4 month old battery when charged up using a good 40 amp charger for 3 hrs, then sitting for 10 hours, never seems to get above 11.9 volts, unless charger is turned back on, then I get the 13.2 volts.
I tested both sides of the connector as shown in photo I texted. No power . Not sure what that connector does. Haven't found the starter interrupt yet, having trouble getting my head under the dash,...going to get a hand held mirror to help see up there.
Not sure how to identify specific terminals....
I have attempted to try to get ohm readings on fuel injectors with plenum in place. I pull #1 inj fuse, then plug a lead wire from front half of fuse holder to a tester lead, then take other lead onto a paper clip and probe the pin sockets on the left hand ECM plug. I tried with battery disconnected .... Can't get anything to read.....I followed a description from Marc H, no readings. I wonder if I am not getting the right place to hook the grounding side in the fuse box ?
Sent from my iPhone using
ZR-1 Net Registry