ZR-1 Net Registry Forums - View Single Post

Livin' in the 80's · 03-31-2017

I rolled the dice on the Lines from ZIP and installed them last night. I used a 1 1/2" open ended wrench and tapped on the wrench with a lead hammer and they loosened right up. I used a little silicone to hold the rubber o rings in place like a glue. I didn't over tighten any of the fasteners.

03-31-2017	#26
Livin' in the 80's Join Date: Feb 2017 Location: Southbury CT Posts: 101	Re: Oil Cooler Line replacement I rolled the dice on the Lines from ZIP and installed them last night. I used a 1 1/2" open ended wrench and tapped on the wrench with a lead hammer and they loosened right up. I used a little silicone to hold the rubber o rings in place like a glue. I didn't over tighten any of the fasteners.