Quote:
Originally Posted by iree75
The mods I have envisioned are long tubes and perhaps some HRE or Fikse wheels... probably a clutch job in its future.
Thanks in advance for advice (I've been pouring over this forum for a while.) -Frank
|
Welcome
I installed a Rebuilt 91' Trans with short shifter (ZFdoc) in my 95' (#186 with two Dunn Heads) with a new needle Pilot Bearing
Pilot Bearing
Also new Clutch Plate and new Throwout Bearing
Throwout Bearings and Clutch Forks
Remember to install the C4 Beam Plates from
ZFdoc C4 Beam Plates
C4 Beam Plates and Installation
Also installed new U-Joints on the main drive shaft
