Quote:
Originally Posted by WVZR-1
I believe that at every location where you had a rivet there's a depression that you can modify the hood to use the M6.3X1.81 screw and the u-clip. I've a '95 hood here but it's buried bottom side to the wall and I doubt I'll have a chance to get at it early but maybe late in the day.I'll try to post back with a solution OR maybe someone has done it.
The screw you'll need is the same as the liners to the fascia and fender panels on earlier cars with the T-30 Torx or the ones used on the later years with I believe a hex. Here's an Ecklers link to what would have been on the earlier thru likely '92 hoods. Not hinting towards a buy but just showing you what I expect on earlier cars.
http://www.ecklerscorvette.com/corve...1984-1990.html
If you search eBay for 11514290 you can catch a glimpse of the nut that would be used.
http://www.ebay.com/sch/i.html?_from...14290&_sacat=0 |
Appreciate the info, will check it out. Whenever you look at the 95 hood is fine. I still have to clean and paint....
BTW, would you know what shade or type of black paint is used for the fender covers and under the hood? thanks for any info.....