Quote:
Originally Posted by Xdt
RussMcB,
I will drain some of the coolant and bleed system again. Any ideas of an alternate bleed method?
|
Are the two Injector Housing Coolant Manifolds getting warm within a minute? If so.....your coolant is flowing and the water pump is working.
And you do not have an Air Locked Water Pump. That is the only purpose of the methods you used is to insure you do not have an air locked water pump.
Now....if the Injector Housing Coolant Manifolds do not get warm.....your water pump is Air Locked or the Impeller is spinning on the shaft.
We are also assuming you installed the Thermostat correctly. We are also assuming it is a 180 deg Thermostat although any degree thermostat should allow the Injector Coolant Manifolds to get warm within a minute.
Am also assuming you did not remove the belt and install it incorrectly and coolant hoses are installed correctly.
Quote:
Originally Posted by Xdt
coolant was overflowing through reservoir high fill, .
Thank you
|
What exactly does this mean???
Sounds like the water pump is working but the thermostat is installed incorrectly........but......an explanation is required.