View Single Post
Old 04-24-2016   #5
Dynomite
 
Dynomite's Avatar
 
Join Date: Aug 2009
Location: South Dakota/California
Posts: 3,815
Default Re: vacuum issues,....

Quote:
Originally Posted by rush91 View Post
My bad. You are right I am mixing two issues. I could always hear the pump under the headlight turn on when the ignition would be turned on, but not started. It then would buzz about every 10-15 seconds. Now I hear nothing except the fuel pump....... should I start to see if the vacuum fuse has blown?
You could start with ignition key on and check for 12 v at the Vacuum Pump. If no 12 volts...then fuse or wiring....if 12 volts...then vacuum pump.
If vacuum pump....pressure sensing circuit or pump circuit.

Quote:
Originally Posted by WVZR-1 View Post
Vacuum pump is a 10AMP IN-LINE fuse over near the grounds etc in the vicinity of the battery on the LH rear wheel-house panel? If you have a FSM it's in the image at 8A-201-8 in book 2.
Is that the same location of the Vacuum Pump Fuse for the 1990?

Thanks for the information......

Quote:
Originally Posted by MuRCieLaGo View Post
There it is, thanks a lot! It was blown so I changed it. Vacuum pump is now working.
Just inside and to the rear of the Drivers Side Front
Wheel House Panel almost directly below the Brake Cylinders



Quote:
Originally Posted by MuRCieLaGo View Post
Vacuum pump is now working.
However, it turns on every 2 seconds or so when key is on. Vacuum leak?
Yes...you have a vacuum leak

Finding A Vacuum Leak

Last edited by Dynomite; 04-24-2016 at 11:23 PM.
Dynomite is offline   Reply With Quote