ZR-1 Net Registry Forums - View Single Post

Dmod81 · 11-28-2015

I was going to install my new stainless works headers, and as I checked the driver's side header for straightness, I noticed that it was warped by .045" in between #1 and #3. Each port is straight, it's warped with the straight edge across the whole flange though. Will it still seal?

11-28-2015	#1
Dmod81 Join Date: Mar 2010 Location: Colorado Springs CO Posts: 76	Stainless Works Header Warped I was going to install my new stainless works headers, and as I checked the driver's side header for straightness, I noticed that it was warped by .045" in between #1 and #3. Each port is straight, it's warped with the straight edge across the whole flange though. Will it still seal?