Quote:
Originally Posted by Racinfan83
All set up and ready for install. I used the plastic clamps that came with the pumps. I know everyone says use the steel but ive never had an issue (ive only done 4 -5 pumps or so over the years) but never had it come apart. I think some people over tighten them which stresses the plastic and eventually can lead to failure. I zip tied the strainers to mimic the oem setup as both were the same part # Denso units.
 |
So that whole thing just drops in the tank from the top where the fuel filler door is? Never looked into fuel pumps... Not as bad as I thought if you can do it with tank in car....[/QUOTE]
Yes the whole thing slides down from the top into the tank. Just have to remove the lid (4 screws) the rubber drain shield thing (not sure what its called) and the 10 or so bolts and fuel lines on the pump assembly to the tank. Its not very difficult at all. It may look like it cant fit but it does quite easily. a few slight turns while going down is all it takes.
