All set up and ready for install. I used the plastic clamps that came with the pumps. I know everyone says use the steel but ive never had an issue (ive only done 4 -5 pumps or so over the years) but never had it come apart. I think some people over tighten them which stresses the plastic and eventually can lead to failure. I zip tied the strainers to mimic the oem setup as both were the same part # Denso units.
[/QUOTE]
So that whole thing just drops in the tank from the top where the fuel filler door is? Never looked into fuel pumps... Not as bad as I thought if you can do it with tank in car....