Did another Clearing of 1990 INFL REST light today......It is nice to get those INFL REST code warnings (INFL REST) off the screen (Code 16 or Code 26)
Note the Code Clearing Method that seems to work best and the most difficult to get at Passenger Side Accelerometer Sensor below
For the Passenger side Accelerometer Sensor for Infl Rest......
Remove the side panel. Leave tire and wheel in place.
Remove wheel well (rear of front wheel.....all 10mm bolts (three on slider, one below slider, two lower middle, one under wheel well)
Remove Windshield Washer Bottle (three 10 mm bolts).
Remove Sensor (one 10 mm bolt and one 13 mm bolt).
Use Emory Cloth and sand contact surfaces on Frame Rail and Sensor.
Replace sensor (10 mm and 13 mm Bolts).
Spray Paint with Black Rustoleum all around sensor and sensor Bolts.
Clearing Codes using the ALDL.
Ground K to A (
I actually grounded K to the Seat Frame).
Turn on key to ACC
Wait for Infl Rest to flash and remove ground for 3 seconds. (
I actually waited for the Code 26 (or code 16) to start flashing).
Re-apply ground for 3 seconds.
After removing ground wait 10 seconds.
Turn key off and remove ground to K.