ZR-1 Net Registry Forums - View Single Post

cvette98pacecar · 11-06-2014

If you have a wet dry vac try to suck out as much of the water as you can. Than change the port to exhaust and blow out the area's under the plenum where you can get the nozzle in the openings.

If you have access to a blow gun and a compressor blow out as much water as you can.

Additionally take some small caps and fill them half way up with salt and strategically place them in the engine compartment to absorb the moisture.

11-06-2014	#6
cvette98pacecar Join Date: May 2011 Location: Sydney, Australia Posts: 2,466	Re: wet motor If you have a wet dry vac try to suck out as much of the water as you can. Than change the port to exhaust and blow out the area's under the plenum where you can get the nozzle in the openings. If you have access to a blow gun and a compressor blow out as much water as you can. Additionally take some small caps and fill them half way up with salt and strategically place them in the engine compartment to absorb the moisture.