View Single Post
Old 11-02-2014   #8
A26B
 
A26B's Avatar
 
Join Date: Dec 2003
Location: Arcadia, OK
Posts: 3,404
Default Re: Cam Cover questions and other stuff

Quote:
Originally Posted by -=Jeff=- View Post
So when I had them off before I just used the anaerobic on the cam cover to head mating surface and not on the buttons/plugs.

I plan to pull the covers off to install the correct filter/breathers on both sides.. then clean and reseal surfaces but wanted to confirm if I should add the anaerobic sealer to the buttons.. sounds like it can be done but is not specifically required
I have found that some of the hard, sealant remnants on the end plugs is removed fairly easily & sometimes not so easy and ended up damaging the seal lip on the plug. So just use care and examine the seal for damage. Remember that anaerobic sealants cure in the absence of air. If air can reach it, it will not cure, i.e. if the thin sealing lip is damaged, the anaerobic sealant won't help that any.
__________________
Jerry Downey
JERRYS LT5 GASKETS & PARTS
http://www.jerrysgaskets.com
1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc.
2016 Black-Red, 3LT-Z51 Auto 8-speed.
A26B is offline   Reply With Quote