ZR-1 Net Registry Forums - View Single Post

zrss · 09-26-2014

Lowering didn't work out quite as I hoped. The nose is a little less than 1/2" inch lower. I removed the factory rubber pads, installed the VBandP pads, and reinstalled the shims (my car has a green spring), which the instructions said would lower it about a full inch. If I get ambitious I may remove the shims to get more drop and see if that gets me close to the 1" drop I was looking for.

I like the look of USAZR1's car but wonder if that's not a little too low, at least for the washboards they call streets where I live.

09-26-2014	#10
zrss Join Date: Dec 2006 Location: Montana Posts: 64	Re: Help Lowering My Z Lowering didn't work out quite as I hoped. The nose is a little less than 1/2" inch lower. I removed the factory rubber pads, installed the VBandP pads, and reinstalled the shims (my car has a green spring), which the instructions said would lower it about a full inch. If I get ambitious I may remove the shims to get more drop and see if that gets me close to the 1" drop I was looking for. I like the look of USAZR1's car but wonder if that's not a little too low, at least for the washboards they call streets where I live.