ZR-1 Net Registry Forums - View Single Post

LGAFF · 08-18-2014

*Loosen the 10mm nuts on the ECM....place to the side..
Master is under the ECM

*Remove the ECM bracket: unbolt the 10MM bolt to the cross brace, unplug the MAP sensor

*Remove the battery (Torx heads and 10MM socket to lower fender/battery cover) 13mm for hold down behind battery(don't forget the 10mm bolt on the top of the panel....its covered by a piece of weatherstripping)

This will allow access to the master

08-18-2014	#3
LGAFF Join Date: Mar 2007 Location: Crystal Lake, IL Posts: 7,180	Re: Clutch Master Replacement Loosen the 10mm nuts on the ECM....place to the side.. Master is under the ECM Remove the ECM bracket: unbolt the 10MM bolt to the cross brace, unplug the MAP sensor Remove the battery (Torx heads and 10MM socket to lower fender/battery cover) 13mm for hold down behind battery(don't forget the 10mm bolt on the top of the panel....its covered by a piece of weatherstripping) This will allow access to the master __________________ LGAFF 90 #966-150K miles-sold 92 #234-sold 1987 Callaway TT #17 1991 ZR-1 #1359 Last edited by LGAFF; 08-19-2014 at 07:20 AM.*