ZR-1 Net Registry Forums - View Single Post - post only, restore my zr-1

batchman · 08-15-2014

I found the old injectors hard to pull out probably since the o-rings are so old. The new primaries "popped" in place with new o-rings, the new secondaries felt loose until the fuel rail clamped them down.

I suspect a different problem. It is easy to pinch the injector wiring or to have a connector not seated. I would try the ohm test on primary injectors to see if all are "happy" - if one is shorted it may be bad or wire pinched, if one is infinite it may not be plugged in all the way.

HTH,
- Jeff

08-15-2014	#34
batchman Join Date: Jun 2009 Location: I live at Devens, one run at a time Posts: 454	Re: post only, restore my zr-1 I found the old injectors hard to pull out probably since the o-rings are so old. The new primaries "popped" in place with new o-rings, the new secondaries felt loose until the fuel rail clamped them down. I suspect a different problem. It is easy to pinch the injector wiring or to have a connector not seated. I would try the ohm test on primary injectors to see if all are "happy" - if one is shorted it may be bad or wire pinched, if one is infinite it may not be plugged in all the way. HTH, - Jeff