I got water in the tank.
Q: Does the fuel pump jumper push both pumps?
----------------------
[edit: THE FUEL PUMP JUMPER PUSHES BOTH PUMPS!!!]
--------------------
Last week I had a mild sputter. Next day it was worse. No SES. Then I remembered
water in the filler neck. Gas cap had been tight, and it hisses when removed, so I thought, 'good seal', water didn't get in, even after it filled AGAIN the day after I pulled the Junebug
Sunday hard start, then NO START.
FP test yesterday.
Paper towel for spill:
Tape the release valve on the FP gauge, and jump the pump test terminal til fuel comes through clear.
Result:
I put in a Heet Water Remover in the tank.
Then sprayed starting fluid into the TB, and it fired, but only for a moment.
Hopefully today the water is in solution...
Ideas?