ZR-1 Net Registry Forums - View Single Post

SharkPilot · 06-14-2007

Okay, I was finally able to get out there and take a look.

The ID looks to be about 0.6" and the OD is 0.925". Since the hose is molded the OD varies a bit from .925 to .950.
Let me know if you need a photo of the end view of the cut hose. I can snap one and attach it here.

Hope this helps,
Jim

06-14-2007	#4
SharkPilot Join Date: Aug 2005 Location: Anaheim, California Posts: 105	Re: ID/OD of oil cooler hoses? Okay, I was finally able to get out there and take a look. The ID looks to be about 0.6" and the OD is 0.925". Since the hose is molded the OD varies a bit from .925 to .950. Let me know if you need a photo of the end view of the cut hose. I can snap one and attach it here. Hope this helps, Jim