Quote:
Originally Posted by Schrade
Ok - just read the whole thread (obviously it will take several read-throughs to get it too).
In the mean time;
Should I install headers AFTER doing INJ balance test? Does it matter?
Dom - you said nothing needs be done if user has stock INJ's; what's that mean?
Do I need several C/L cycles before looking at INJ's PW? Does THAT matter?
|
1. No reason not to install headers
2. The values in the calibration for injector offset is for stock injectors. If that's what you have, then no need to modify cal. There's no mandatory need to change if you are using other than stock. Again, it comes down to making sure things are mechanically sound requiring minimum ECM intervention.
3. Not sure what viewing Inj. PW is supposed to do. It becomes an issue at WOT when concerned w injector Duty Cycle %. At these power levels, should be
non issue.