ZR-1 Net Registry Forums - View Single Post

Franke · 11-04-2013

I don't think so as the CC tube is larger in inside diameter I think. Jerry's has a new CC pipe however its a bit pricey. I was thinking that maybe you could wiggle a slightly smaller PVC pipe or something similar through the hose up to the defect and then clamp it. Maybe not but I tend to analyze why parts like that fail since there isn't a lot of pressure etc on them. Got to be oil and heat breakdown or friction on a adjacent part. High temp RTV might work too if allowed to setup properly.

11-04-2013	#150
Franke Join Date: May 2013 Location: Beaver, PA Posts: 515	Re: TOP END REFINISHING I don't think so as the CC tube is larger in inside diameter I think. Jerry's has a new CC pipe however its a bit pricey. I was thinking that maybe you could wiggle a slightly smaller PVC pipe or something similar through the hose up to the defect and then clamp it. Maybe not but I tend to analyze why parts like that fail since there isn't a lot of pressure etc on them. Got to be oil and heat breakdown or friction on a adjacent part. High temp RTV might work too if allowed to setup properly.