ZR-1 Net Registry Forums - View Single Post

Schrade · 11-02-2013

So set the P side IH.

Blot the head surface with a paper towel:

clean (Jerry said DRY, no thin grease film, as I'm accustomed)

Set the gasket; make sure they're aligned with a Phillips head (WTH is Phillips anyway? )

11-02-2013	#120
Schrade Join Date: Dec 2012 Location: NC Posts: 1,783	Re: TOP END REFINISHING So set the P side IH. Blot the head surface with a paper towel: clean (Jerry said DRY, no thin grease film, as I'm accustomed) Set the gasket; make sure they're aligned with a Phillips head (WTH is Phillips anyway? )