ZR-1 Net Registry Forums - View Single Post - Reassembled Plenum to Motor - No Start

dondon · 10-20-2013

Thanks to everyone for the help.

Today I took plenum off again. One pin looked a little fishy, I corrected as best I could. Reassembled... No Start.

I began to scour the net for information, made an offer on a DIS module currently on EBAY. Researched more, and went back to chart A-3 (page 3 of 4). Followed the eventualities and ended up checking the fuse for the "Guages".

It had blown. Replaced the fuse with another fuse in the box. Turned the key and car started right up. Apart from the ego blow and the loss of a day I'm pretty ecstatic about it. Wish I'd just checked the fuse... that may have been the problem all along.

---------------
Solution : Blown Guage Fuse (10A) replaced.

10-20-2013	#4
dondon Join Date: Jul 2013 Location: Saint Petersburg, FL Posts: 32	Re: Reassembled Plenum to Motor - No Start - 0 RPM Cranking Thanks to everyone for the help. Today I took plenum off again. One pin looked a little fishy, I corrected as best I could. Reassembled... No Start. I began to scour the net for information, made an offer on a DIS module currently on EBAY. Researched more, and went back to chart A-3 (page 3 of 4). Followed the eventualities and ended up checking the fuse for the "Guages". It had blown. Replaced the fuse with another fuse in the box. Turned the key and car started right up. Apart from the ego blow and the loss of a day I'm pretty ecstatic about it. Wish I'd just checked the fuse... that may have been the problem all along. --------------- Solution : Blown Guage Fuse (10A) replaced.